rus | eng | gr
tel.: +7 (3812) 37-22-37, 31-00-33

Electrochemical power source Activator AEAC-12V

Electrochemical power source Activator (Activator) is intended for battery maintenance, training and state checking.

Technological documents on

AEAC Activator is professional equipment intended for diagnostics, putting in operation and maintenance of batteries of ALL types.

ONE device. ANY batteries.

Activator can be connected to PC via Ethernet.
No software installation required - software works in browser.



1. Built-in load provides possibility to:
- Desulphate battery
- Estimate REAL capacity
2. 4-wire measurement circuit for precise voltage and resistance measurements
3. Maintenance program is created automatically according to parameters set by user:
just select battery type, nominal voltage, capacity and condition of the battery.
4. Possibility to maintenance individual elements of multi-element battery
5. Full control over maintenance program - it is possible to add any amount of charge/discharge stages if necessary
6. Device builds charts representing maintenance process.
With these charts, it is easy to find problems such as defective cells or separator breakdown

Activator is a stationary device supplied by AC Mains with 220(230)VAC 50(60) Hz.


ABLogger is the device intended for condition monitoring of battery charging devices and electrical systems equipped with a battery (vehicle electrical on-board systems, alternative power sources).
AEMT series measuring transducers are intended to be used for measuring electrical quantities in AC, DC and pulse current circuits.

Electrochemical power source Activator (Activator) is intended for battery maintenance, training and state checking.

Electrochemical power sources (batteries) analyzer
Multifunction measuring transducers for measuring electrical parameters of three-phase circuits
Measuring transducers with unified current output. (13)
AEDC are meant for measuring DC current and DC voltage. Analogue current input and RS-485 interface. (3)
Indication devices AED and AEGD are meant for connecting to measuring regenerator AET to indicate measuring results. (2)
Преобразователь электрический измерительный АЕМТ предназначен для измерения электрических величин в цепях постоянного, переменного и пульсирующего тока.