rus | eng | gr
tel.: +7 (3812) 37-22-37, 31-00-33

Measuring transducer E1859

Active power measuring transducers. Meant for use in 380V circuits without external primary transformers.

Description E1859

Technical characteristics:

Type I out.,
mA
Output parameters Pconsump. on measured circuit,
VA, not more than
Рconsump. on power supply, VA Accuracy class
U, V I, A
1 Е1859А2 0..5 0..456 0..0,5
0..1
0..2,5
0-5
0,6 on
АС, АВ, СВ 0,2 on each serial
not more than 3 0,5
2 Е1859АР2 0..2,5..5
3 Е1859В2 4..20
4 Е1859ВР2 4..12..20
5 Е1859С2 0..20
6 Е1859СР2 0..10..20
7 Е1859ЕР2 -5..0..5

Dimentions 120х80х120 mm
Weight not more than 0,9 kg.
Power supply – AC 187-242V 50 Hz frequency.
Time of setting output signal in case of input signal hopping to any value in measured range – not more than 0,5 s.
Time of setteng working condition – not more than 15 min.
Worktime between failures – not less than 95 000 h.
Average lifetime – not less than 15 years.

Note: These transducers are meant for 380V circuit usage. No additional primary measuring voltage transformers needed.

Catalog:

Устройство для контроля состояния сети электропитания транспортных средств или альтернативных источников энергии, установленных на них аккумуляторных батарей и зарядных устройств.
ABLogger is the device intended for condition monitoring of battery charging devices and electrical systems equipped with a battery (vehicle electrical on-board systems, alternative power sources).
AEMT series measuring transducers are intended to be used for measuring electrical quantities in AC, DC and pulse current circuits.

Electrochemical power source Activator (Activator) is intended for battery maintenance, training and state checking.

Electrochemical power sources (batteries) analyzer
Multifunction measuring transducers for measuring electrical parameters of three-phase circuits
Measuring transducers with unified current output. (13)
AEDC are meant for measuring DC current and DC voltage. Analogue current input and RS-485 interface. (3)
Indication devices AED and AEGD are meant for connecting to measuring regenerator AET to indicate measuring results. (2)
Преобразователь электрический измерительный АЕМТ предназначен для измерения электрических величин в цепях постоянного, переменного и пульсирующего тока.