rus | eng | gr
tel.: +7 (3812) 37-22-37, 31-00-33

ABLogger

ABLogger is the device intended for condition monitoring of battery charging devices and electrical systems equipped with a battery (vehicle electrical on-board systems, alternative power sources).

Technological documents on ABLogger

 

Battery charge and power consumption calculations

No need to break the circuit while installing

After ABLogger was installed on the vehicle, no more operations are required – it saves time and effort of the specialist. Owner can use his vehicle the way he usually does.

Current measurements up to ± 300 A (two channels: 300 A and 50 A);

Voltage measurements:

  Supply voltage, V
  Nominal Minimum Maximum
ABLogger-24 24 8,4 36
ABLogger-48 48 16,8 72
ABLogger-72 72 36 108

Sometimes, it is needed to check whole system as well as its individual parts. In this case, it is possbile to use several ABLogger devices.

Software

The software for configuring the device and visualization of recorded data is on CD from the bundle. Latest version is available on site.

 

Catalog:

Устройство для контроля состояния сети электропитания транспортных средств или альтернативных источников энергии, установленных на них аккумуляторных батарей и зарядных устройств.
ABLogger is the device intended for condition monitoring of battery charging devices and electrical systems equipped with a battery (vehicle electrical on-board systems, alternative power sources).
AEMT series measuring transducers are intended to be used for measuring electrical quantities in AC, DC and pulse current circuits.

Electrochemical power source Activator (Activator) is intended for battery maintenance, training and state checking.

Electrochemical power sources (batteries) analyzer
Multifunction measuring transducers for measuring electrical parameters of three-phase circuits
Measuring transducers with unified current output. (13)
AEDC are meant for measuring DC current and DC voltage. Analogue current input and RS-485 interface. (3)
Indication devices AED and AEGD are meant for connecting to measuring regenerator AET to indicate measuring results. (2)
Преобразователь электрический измерительный АЕМТ предназначен для измерения электрических величин в цепях постоянного, переменного и пульсирующего тока.